a4000 csppc EXCEPTION ERROR ON RAMLIB_PPC WHEN OPENS WARD3D APSS!!!HELP!!! PROBLEM SOLVED!!

[tolishot]

you have broken your csppc?in my condition the problem shows after crash my hard disk!after that i dont know what happens  the software never works like the last installation on the broken hard disk!!i try today to fix the broken disk and if the works after i will copy this disk in another new.then i hope to see what libs i put it there and the differense on the new installation.the new installation shows the exception error!in the broken disk never shows that!!i am confused about that!i must to find the mistake!and then i post with big letters I FOUNDED!!!!!  :-D

[tolishot]

take care for the csppc!!it is very sensitive device!in my case i will put out the 68060/50 and put another one 68060/66.
crystal and other working fine.in cvppc i put in all chips metall cooling from zalman or other..!

[tolishot]

[tolishot]

ok!better solution is cooling!the differense about the overclock is to small!from 200 to 233 on the ppc cpu is stable but to hot from beggining!i will put out  the original cooler and construct other from asus mainboard chipset.is to tall from old and too cold!with chipset fan is best.my two cards is  cold from start and after playning 10 3d demos following its other!for best solution put a 8cm or 12cm fan 12v from the side of ram!maybe some message appears from hot environment!
after 3 hours i send you some fotos to see ok?cu later!

[tolishot]

BINGO!!!!MY PROBLEM IS SOLVED!!!COOL!I FOUND THE PROBLEM!!MY CSPPC WORKING FINE WITH ALL WARP3D APPS!!WARPOS WORK OK TOO! :-D  :-D  :-D  :idea:  :idea:  :roll:  :rtfm:

[tolishot]

ok!i have fix the problem of the csppc.works fine to all 3d apps!the problem is the cgx driver!i install the ver 42.0 of cgx!after that run it the planet potion demo!cool to all!after that the potion option!the same !!runs fine!all the 3d demos heretic game works!i hope to help for this!! :rtfm:

[tolishot]

basicaly the problem is the prcedure instalation of warp3d warpos and cgx system!!if you install first cgx and the other next then be crash the os when you run 3d apps!so i install first warpos5.1update after the powerpc support from os3.9 and after the 2 updates bb1 and bb2.next the warp3d4.2a and last the cgx drivers ver42.0 from cgx cd instalation.after all the warp3d apps and demos with games works fine!some times after playning ppc demos show a message not memory for zbuffer!this message appears when you let the setting as graphics memory from sys/prefs/workbench!you must change it from graphic memory to other memory!
and some other problem !when i finish all installation before find the correct procedure setup the settings of cvppc on the monitors.38khz default screen and after select the correct resolution for my monitor.restart and after that i lost from screenmode the cvppc!????demos ppc canot find the resolutions.if you not shows the cvppc in the screen modes you must install again the cgx driver from cd!restart and then shows again the all screen resolution of cvppc!!thats all my friends!! :-D  :-D  :-D  :rtfm: