Indivision ECS Scandoubler showing lines

[kirk_m]

Hi

I have bought a indivision ecs for my amiga 2000 system but its showing lines on the lcd screen is that normal or as my indivision have a fault:confused:

Are you using it with a monitor that has DVI or a VGA connector?  If you're using it with a regular VGA 15 pin, you need to disable the digital output from the card, via the indivision tools on their support site (this applies to vertical lines).

[kirk_m]

Since when does the Indivision ECS have a digital output?

Sorry, I might have confused it with the MK2.  In the instructions, it says if you have vertical lines present on your display, you need to go into the indivision utility where you set its modes, and disable DVI output and only enable VGA.  I had that, so, that's what I did (since I was using it on a monitor that did not have a DVI input and used a DVI --> VGA adapter on it).