G-REX PCI 1200 problems

[djbase]

Painkiller wrote:
And no, that is not my promlem you know that you can hardwire the socket to accept the ATX wakeup signal.

See:
http://grex.amigaworld.de/index.php?lang=en&page=46

Hm, you understand german?  :-)

[djbase]

To power up it well with ATX you need a trick :
put a wire between the green cable and a black one.

Its not needed if you put a bridge on the empty PIC socket. There are two ways like shown on the pictures.

1. to turn on/off the PSU by using its own switch (most psu have a switch on the back)

2. to turn on/off the PSU by using the switch on the tower

[djbase]

Remember to use an on/off switch not a button if you choose solution 2.

[djbase]

pyrre wrote:
Hello painkiller
I was in contact with DCE in august 2007. I spoke to a nice guy telling me all i needed was a disk to flash some of the firmware to upgrade to rev 2.

AFAIK the update from Rev.0 to Rev.2 would require a CPLD update which can't be done using some sort of bootdisk like the normal flash update.

[djbase]

You can check on the floppy power plug on the board if the +5V are strong enough.