Electrohome ECM1310 Multisync Help!

[Zero]

I have just got hold of an Electrohome ECM1310 Multisync monitor, it works fine and gives a good display dispite it's age, made in 1986!

I am using it on my 4000/40 (spec in my sig).
It's to replace my 1084S.

I want to know whats the best mode to run it in.
I currently running it in DBLPAL High Res No Flicker, and this seems to be the best mode, as a lot of the other screen modes are almost impossable to center, even with overscan.

Any help would be great!

[Zero]

... MULTISCAN:Productivity seems quite good as well.

Also do I need the VGA Driver in Devs/Monitors

Thanks in advance  :-)

[Zero]

Whoops! it's an Electrohome ECM1311 Multisync Monitor.
Still need advice if any is going!  :-D

[Zero]

 :bump:

Anyone?

 :-)

[Zero]

@Boot_WB

Thanks dude, I will have a look and I will be careful.

 :-)