Welcome, Guest. Please login or register.
Forums
« previous next »
Pages: [1]   Go Down

Author Topic: installing ppc  (Read 1688 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline orangeTopic starter

  • Hero Member
  • *****
  • Join Date: Dec 2003
  • Posts: 2799
  • Country: 00
    • Show all replies
installing ppc
« on: December 12, 2007, 07:16:53 AM »
Is it possible to install Bvision in A1200 without removing the RF shielding?
Can the entire computer with ppc and bvision be powered from floppy connector only? (for testing)
Logged
“Giving up is always an option, but not always a failure.”
 

Offline orangeTopic starter

  • Hero Member
  • *****
  • Join Date: Dec 2003
  • Posts: 2799
  • Country: 00
    • Show all replies
Re: installing ppc
« Reply #1 on: December 12, 2007, 10:46:56 AM »
thanks for replies.

Quote
You need to remove the shielding for installation at least.


because of the two screws? I had an idea to solder the two bolts to ppc card, insert the ppc and then easily attach bvision with screws.
Logged
“Giving up is always an option, but not always a failure.”
 

Offline orangeTopic starter

  • Hero Member
  • *****
  • Join Date: Dec 2003
  • Posts: 2799
  • Country: 00
    • Show all replies
Re: installing ppc
« Reply #2 on: December 12, 2007, 01:12:31 PM »
I see..  
the thing is; I have no HDD cradle and the drive is screwed to the metal shielding; also, I was worried about interference; A1200 seems protected with it (from a small amount of water for eg..)
Do you think I could at least keep the bottom half of shielding?
Logged
“Giving up is always an option, but not always a failure.”
 
Pages: [1]   Go Up
« previous next »