Monitor Settings Needed

[maximo]

I currently setting up my CV64/3D (DCE Version) using Picasso96 software. I've got so far with it but can't go much futher.
My system is :-

A1200 / Apollo 60 / Zorro bus board / OS3.5

Ok so I've installed the software and started playing with the settings, I'm able to get a test display come up but when I move the mouse around the display either crashes or just goes all over the place. I've checked out the monitor spec and I think I have a configuration problem. Could someone help with the configuration, monitor details :-

Dot Pitch          0.25mm/0.27mm
Recommend Resolution    1024*768,85Hz
Maximum Resolution       1600*1200
Horizontal Frequency                          30-86KHz
Vertical Frequency        50-160Hz
Dot Rate           145MHz(typical)

Max. Refresh Rate
1600*1200    60Hz
1280*1024    75Hz
1024*768    95Hz
800*600    120Hz
640*480    150Hz

Can someone tell me what I need change on my set-up to get things working.

Cheers

[maximo]

I've tried those settings and don't get anything better. I've tried CGFX version 3, when the monitor driver is loaded it just halts the Amiga which is very odd.

I'm also running a clean installation of OS3.5 no patches or software installed.

[maximo]

Hi Framiga,

It's a clean install of Picasso96. I think I've tried that mode but I'll try again and see what I get.

Cheers

[maximo]

Problem sorted out. I found the VESA settings for the modes. I now have a fully working CV64/3D using Picasso96.