Help needed with CV64 CGX4

[spudje]

I recently got an A3000D with a nice 4MB Cybervision 64.

It runs fine with Picasso69 on OS3.9. Only 32bit screen modes are a bit tricky, some artefacts in the right side of the screen when dragging windows etc. And these windows won't all drag immediately. No problems in 16 bit screens at all.

I bought Cybergraphx 4 and thought. let's also try that. But I got overwhelmed by the installer and all the options. After installing it and straight after updating it to the latest update, on a new clean OS3.9 & BB1+2 partition I get this:



Is it a matter of configuration? Should I check the chips being properly in their sockets or is something really wrong with the C64?

Some clear "dummy" guide on all the Cybergraphx install options would also come in handy. And I really don't fully grasp all the screen mode parameters (frequenties, sizes, etc.)

Thanks in advance!

[spudje]

Thanks both!

@danbeaver: where's that Picasso guide?

@zipper: I already updated to that latest version.

[spudje]

Thanks all!! Tried it again over a clean 3.9 install and got it running in the end.

1024x768 32 bit however has the exact same issues as it has under Picasso, right half of the screen shows a lot of artefacts when dragging windows etc. So I guess that's an issue with the card or maybe the thing is not running at full zorro3. I didn't check the jumpers when installing the card. But is runs absolutely fine in 1024x768 16 bit. so I'll keep it to that.