Hi,
If you get a PAL model, take a look there at the bottom :
http://wonkity.com/~wblock/a1200/a1200.htmlconnecting pin 41 of the Alice custom chip to ground causes the A1200 to default to NTSC, while pulling this pin high (disconnecting it from the motherboard and connecting it to +5V through a 4.7k resistor) will make the default power-up state PAL. I would point out that making a modification like this on a surface-mount chip is difficult at best, and you may end up needing an expensive motherboard replacement, or, at worst, a dead A1200 that needs an expensive replacement motherboard available. In most cases, using the boot menu (obtained by pressing both mouse buttons on power-up or reset) to switch to PAL is sufficient. However, with some games, the hardware patch will be necessary to insure proper timing (changing to PAL via the boot menu might make a 50 Hz game run at 60 Hz timing, or vice versa).
:idea:
I also suggest you A2000 that could have cheaper HDD.
