Welcome, Guest. Please login or register.

Author Topic: NMI Autovector?? ( Whdload )  (Read 5938 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline OrjanTopic starter

  • Hero Member
  • *****
  • Join Date: Sep 2003
  • Posts: 515
    • Show all replies
NMI Autovector?? ( Whdload )
« on: December 25, 2004, 10:48:15 PM »

I´m trying to install a couple of games to my A1200 with a Microbotics 1230XA accelerator with a CPU @50MHz and 64MB RAM..

When I try to run "The Stealth Affair" ( after installing it ) I get to the copy protection stuff, and I get to choose colors twice, and then I get the following error message:

EXCEPTION "NMI AUTOVECTOR" ($7C)
AT $BF74B0E (EXPMEM $4CB0E) OCCURED

 - QUIT - RESTART - MAKE COREDUMP -

I get an almost identical message when I try "Walker" ( memory addresses change somewhat ) but interestingly enough, "Shadow of the Beast" works like a charm..

I have tried the NOMMU command, but the results were the same...

At first I thought I had bought a bad stick of memory, so I downloaded three different memory test programs off aminet.. Two of them reported that all my memory was just fine, but the third one claimed that all my memory was bad, including CHIP.. So I basically ignored that program...

Does anyone have any suggestions/tips, and so on?
\\"Memory is like an orgasm. It\\\'s a lot better if you don\\\'t have to fake it.\\"
- Seymore Cray, on virtual memory.
 

Offline OrjanTopic starter

  • Hero Member
  • *****
  • Join Date: Sep 2003
  • Posts: 515
    • Show all replies
Re: NMI Autovector?? ( Whdload )
« Reply #1 on: December 26, 2004, 12:56:49 PM »

Hum... :-)

But why does this occur in the first place? Is my accelerator broken, or something?
\\"Memory is like an orgasm. It\\\'s a lot better if you don\\\'t have to fake it.\\"
- Seymore Cray, on virtual memory.