SANA-2 config for Mediator 4000 Di & Fastethernet, and more

[doctorq]

The Piccaso96 software is the software needed for Voodoo cards, and the CyberGraphX software is used for Virge cards.

Since you are using a Voodoo card, then you obviously have to install Picasso96. On the MMCD I believe you can find a ReadMe file that descripes how to get the Voodoo card running; read it, and it will be dead simply for you.

As for the ethernet card, there is a difference. The X-Surf card needs a config file placed in ENVARC:SANA2, the PIC ethernet cards doesn't need this. However, it might be nice to have such a config file for the PCI ethernet cards, since my ethernet bridge has to be activated twice when using a PCI ethernet card, and the X-Surf only once.

[doctorq]

Hmm, don't know exactly. Does the program not even start up? If you have installed the CyberGraphX software and haven't uninstalled it, this might be the problem.

Try installing the Mediator software and Picasso96 software on a fresh install of OS3.9; it should get it working.

[doctorq]

@StormLord

Mediator and G-Rex isn't the same, and the same goes for CyberGraphX and Picasso96. Make sure you have the gtlayout.library installed in libs, otherwise CGXMode will not start. At least that is what I have experienced....

[doctorq]

@StormLord

Well, the same advice goes for you; try to install a fresh OS and try installing the CyberGraphX software again. IMHO it is not a good idea to install several RTG graphics boards on the same boot partition.

BTW. since the problems your are having is related to a different graphics software system, then a solution for the Picasso96 issue most likely isn't suitable for the CybeGraphX issue.