Subway USB Controller for the Amiga 1200 Clockport

[System]

USB-Controller for Amiga 1200 compatible clockports

Technical data:

[*]compatible with USB 1.1 and USB 2.0 specification (no highspeed mode)
[*]integrated 4-port hub
[*]all ports are protected against overvoltage and short circuit
[*]integrated power management on port by port base
[*]power saving 3.3V technology
[*]compatible with all 68030/040/060 and PPC turbo cards
[*]no mechanical problems with Amiga 1200 bus boards
[*]compatible with all Amiga 1200 tower housings
[*]standard Amiga 1200 clockport connector
[*]works with all Amiga 1200 compatible clockports
[/LIST]
 Hardware Compatibility List

Software:

[*]integration into AmigaOS via system conform drivers
[*]comfortable control of commodity driver by hotkeys
[*]driver for USB mouse, keyboard, serial and parallel interface
[*]further drivers (webcam, digicam) also by third companies under development
[/LIST]


Package contents:

[*]1 Subway USB controller card
[*]1 10cm clockport flat ribbon cable
[*]2 holding plates with two USB connectors each
[*]1 detailed installation manual
[*]1 disk with driver software
[/LIST]


System requirements:

[*]Amiga OS 3.1 or higher
[*]Processor 68030 (25 MHz) or higher
[*]100% compatible Amiga 1200 clockport
[*]power supply with 2.0 Ampere minimum on 5V (each used USB port will use a maximum of 500mA, depending on connected device)
[/LIST]

See also: Deneb USB Controller for Amiga computers w/ Zorro-II/III

EUR 92.90

More...