Seems that every time I add something new to my A4k it throws up a new and difficult issue!
The latest one: Bought a Cyberstorm 060 Mk1, since fitting it it will take a few resets to display through my Cybervision 64/3d. Once it's displayed it is fine until a power off (resets are fine). Also, if I try to change the screen mode the Amiga crashes to a software failure.
I thought I may have a software problem, so did a clean install with WB3.1 - installed latest 060 install disk from phase5's website - Installed Cybergraphx 4 and it has the same problem leading me to believe it's a hardware issue.
If I remove the 060 and fit my A3640 (clocked at 33mhz so jumpers are set to EXT) everything is fine and fixed.
Now, it has a Buster Rev9 and I've read about Zorro issues with accelerator cards above 25mhz on this revision.
Can anyone confirm that it's a buster issue or have I missed some thing? your advice is welcome as this money-pit of a machine is turning my hair grey(er).
(Amiga 4000 RevB re-capped recently / Rev9 Buster / Cyberstorm MK1 060@50 / 2mb chip, 16mb on motherboard, 96mb on Cyberstorm / 2x4gb CF Hdd's and DVD rom on 4xIDE interface, Cybervision 64/3D with Scandoubler / OS3.9 w/boing bag 2 / Cybergrapx 4 / IDEfix 97)
