Amiga 600: Installed WB 3.1. Amiga still boots in WB 2.1.

[andersbm]

Hi all.

Have just tried to install WB 3.1. by using the following method:

Transferred  ADFs to Floppys and made my "brand new" Workbench install set. Started installing Workbench 3.1. and everything seemed  to work smoothly. HOWEVER, when I rebootet after the final message ("The  installation of Release 3.1. is now complete. To enable Release 3.1.  you must reboot your amiga") - WELL, then NOTHING NEW HAPPENS! :-( It still boots in good ole' Workbench 2.1. :-(

I tried installing Workbench 3.1. three times in 3 different languages. Still the same result!

Also,  after rebooting I get an error message: "ERROR: can't load keymap  KEYMAPS:dk. However, I do not believe that this has got anything to do  with the lack of a genuine 3.1. workbench boot.

Anybody have any good ideas on how I should fix this problem?

All best
Anders
Copenhagen

[andersbm]

Yes I do, but I actually think I got it figured out now. It IS WB 3.1. - I was just confused, because it looked EXACTELY like 2.1. and I thought there would be a minimal change :-)