S/H Cybervision 64/3d...please don't say it's DOA!!!!

[Framiga]

@dandelion

mhhh! deleting the CVision monitor is not enoug!

You must delete ALL the CGX related libraries before installing P96.

Unistall CGX3 ALL, and install P96.

Ciao

PS-by the way . . .i doesn't understood where you have installed the CV643D the first time!!!!

[Framiga]

@dandelion

sorry but i'm still have a scary doubt:

WHERE (in which slot) have you installed the board the first time?

A4000D has only 1 videoslot alligned with the ZIII one and it is the first near the mobo.

So . . .has your CV643d the Scandoubler module? (the little board connected with the CV board with a small flat cable)?

If yes, try to remove the Scandoubler and remove the flat cable also. Test the CV64 without the SD.

Remember to remove the CGX related library before installing P96. (ie cgxvideo and cgxsystem)

I'm not 100% sure but SD needs a driver also.

Ciao

PS- i've take a look in the CV3D install disk.
I've noticed that there are different monitor for ZII and ZIII.systems.

[Framiga]

@Matt_H

IIRC the CV643D has a jumper that forces to ZII mode but . . . this isn't the right way IMHO.

@dandelion

try to find the jumper settings, on your CV3D user manual.

Ciao

NOTE- "the CV643D works only with a mobo clock of 25 Mhz, so with some accellerator cards, couldn't works".

"SuperBuster 11 suggested"

By the way: you haven't yet answer if the card has the SD or not (very important for the configuration)

.

[Framiga]

@dandelion

FYI even an A3000 with SB rev 7, works with CV643D.(Phase5)

Personally, i've used my CV64 (not3D) on my A4000D with its original SB9 for years.

Which accelerator card do you have?

Ciao

[Framiga]

@dandelion

take a look HERE.

There is all that you should know, about CV643D :-)

Ciao