A4000T 060 needs help..

[Framiga]

time to reseat/clean contacts/socket!

and check the presence of the 12V on the Zorro slots (look at the A4000 User Giude)

+12v = pin 10

[Framiga]

i meant to say everything with a connector or a socket on the mobo.

SuperBuster, kickstart, quartz Zorro daughter board everything.

Obviously if you don't have the 12v on the Zorro bus, the fault is more difficult to catch. (sorry but i don't know your skills about electronic repairs/restoring)

[Framiga]

the best and reliable you can find around! :-)

Edit- take a look even at the 6 pins "Molex" power connector on the mobo (or better on the mobo close the connector to be 100% sure that the 12v is present)

[Framiga]

OT

just noticed your Idek monitor! i have used one of the same series for years; a MF5121 (now dead.. fixed for 10 times at least)

[Framiga]

i'm on a Dell 17" TFT currently without any problems (CVPPC and CV64 installed on both AmigaOS3.9 and MOS for PowerUP)

[Framiga]

17" and 19" (unfortunately) uses the same resolution (1280x1024)

You have to chose a 16 bit mode (due the 4MB only VideoRam of the CV64)