card reset? none that i know of. i just pull the card out and push it back in again...
anyway,
don't you need the "MANAGED" tooltype for setprism2defualts? i am assuming that you are connecting to a router? or some form for wireless access point?
everything else is the same as mine, except i switched off WEP and all other wireless security on my router, and set the router to only except wireless connections based on trusted MAC addresses. not a problem since.
i think i got WEP to work a couple of times, but it was a pain getting it to work with my G/F's laptop. get it working with the laptop, and it would stop working with my miggy. so i found trusted MACs a better solution.
basicly just keep trying. you may need to force the router to 11mb, as i had problems with it running a dual signal of 11/54mb, and untill you can get it connected, take all the security off so you can rule that out of the question too.
IIRC mine is,
setprism2defaults SSID **** CHANNEL 6 MANAGED
oh yeah, make sure the SSID doesn't have spaces, or weird characters in it. try to keep it a-z, A-Z, 0-9. it is also case sensative.
you were trying to run a special config in the TCP/IP stack setup? you shouldn't need to do that as setprims2defaults does that for you for the wireless stuff.
good luck!
