A1200 HD activity light (not CF related?)

[Coolhand]

So I had a CF HD in the amiga for a year or so, HD activity LED worked fine with this device.  Installed my ACA1232 last weekend, I'm pretty sure the light was happily blinking away after that.

Then I took the entire thing apart to get at the back of the mobo and remove a couple of capacitors, which went perfectly smoothly and fixed up my timing issues pretty much with the 1232.

After re-assembling and booting I have no power going to the HD LED at all :confused: I've tested it with a multimeter while accessing the drive and nothing so its not the LED itself.

Just wondering if its a side effect of the timing fixes (seems unlikely) have I damaged something else or is there a usual suspect I should look out for. I haven't yet taken the board out again to inspect it but what should I look out for when I do?

Thanks.

[Coolhand]

well it worked fine with the exact same cf card and interface for months, one rebuild later it doesn't work... seems like it might be something else to me, either way I don't have a spare card handy to test it out.  do you know what pin that is?

http://www.ntrautanen.fi/computers/hardware/misc/amiga_ide.htm pin 39 then? thats at the upper right if i'm looking at the 1200 from front on presumably?

[Coolhand]

I don't think he has a FastATA(activity wire) I was just using that page to show which pin goes to the LED. I think that pin should have continuity with the LED.

I think most likely its a bent/broken pin or the CF card malfunctioned and quit putting out that signal.

My LEDs on my PCMCIA Wifi card quit working for some strange reason. I suspect maybe the card got slightly bent.. I thought my PCMCIA port died.

yeah its just a normal ide err, thing. Before today i'd have thought something like that would fail the entire drive but bbond is correct... Thanks for your help guys, I took the thing back out, and the pins were not aligned properly - none were actually bent or missing and they must have been in their connector slots before but perhaps not making a proper contact. I put it back in, this time it really 'clicked' home (weird for that type of connector - must be the misaligned pins catching on the plastic or something) and the LED light functioned again... So its working but maybe not quite right. next time its apart maybe i'll check that area under the board