Bvision

[jj]

MY miggy was having  a few probs, to cut along story short I lost everything on my miggy HDD.

I can get the native screen to work through my bvision, but the colours are messed up if u go into 256 colour mode, and  u cant get a res better than 640X320.

If i try to install cybergraphx, any version inc. 3 and all versions of 4, themachine frezees on the cybergraphx pic boot screen. if i remove the monitor file from devs the machine boots.  If i use show graphx config or any prog that trys to access the cybergraphx system the machine crashes and freezes.

any ideas, i miss my miggy, helppppppppppppppp

anyone know if there are  any pogs to test the bvision to c if its working correctly so i can narrow it down to a hw conflict or something or to c if my bvision is fried.

i have been using this setup for over a  year and it has been working fine. helppp

My setup is.

A1200T, powerflyer gold, 2 gig hdd, 10.2 gig hdd, 6 speed cd rom, 3.1 roms, z4 busboard, blizzard 040/25, 603e/175, 64mb ram, octagon scsi, hypercom 3i.

[jj]

@ryu

I also have had every problem under the sun with my bvision and ppc in general.  do u mean the connector between the bviion and ppc board
 it might be heat, u c with a z4 board and power flyer the bvision is trapped between the powerflyer and the z4 board, it gets well hor, but never been a problem b4.

@ the other dude

The problem manifests itself under 3.0, 3.1 and 3.9 an devery version of cybergraphx. though i am not sure if i have tried clean install of jusr 3.9 and 4 rc5 11