I acquired a similar non-working system but I got the A2000 to work.
I don't remember the jumper settings for everything initially, I should have taken a pic...
I have an A3001 rev 8 with a RAM32 board works perfectly installed by itself...
but put in the A2000-hc+8 SCSI board and doesn't recognise the scsi drives.
the A2000-hc+8 scsi board works with KS3.1 but intitial boot up registers and error..
then you can boot from the scsi drive...
please tell me the jumper settings etc how your system booted from the scsi drive.
regards..
Rob *shaman
