Clean Install WB Help

[SACC-guy]

The 4000T is a bit strange because of the true scsi and ide headers.
Also, the workbench.lib was removed from rom

So, if your are using a true scsi drive, and your are using the real 4000T install set...
It's just a matter of setting the partition you want as bootable (as already shared)

Same is true of the ide drive but usually you have to cold boot, the drive light will seem to hang, wait a second and then just soft reset and it should find the ide partition.

M

[SACC-guy]

Oh you have a 060/ppc card?

well, the issue may be the new partition may not have the 060/040 libs!

boot from floppy, install the small 040 and real 060 libs!

BTW, when you do a install from the floppies, it installs the 040 lib from the disk. over writing the small 040 lib

I made an install 3.1 floppy with the 060 libs...

[SACC-guy]

Yes, it will work with a new drive.

but, deep breath, 98 percent of the issues are libs related

please try the correct small 040 libs and correct 060 lib install.