I actually ran it off the bodged together power supply at the bottom of the pic for a few hours, the regulators and/or inductors got hot enough that you could smell them from outside the case, and there's a module that does +-12volts, with a resistor on the positive rail, as I was only using the negative rail... There's capacitors on the bottom, fake Rubycon most likely
The final design above still isn't the final, one regulator isn't soldered on, as its the wrong part, and I plan to run bigger inductors all round, so I'll finish this board, make sure it works, then build another (I etched two already)
