NTSC By Default

[k4lmp]

I have WB 3.1 installed on one of my CF hard drives.  I installed MagicWB, which I like rather well, not so boring.  Now, when I boot, unless I hold down both mouse buttons and select NTSC, it will always boot in PAL.  I hold the buttons down, choose NTSC, it boots, I go to screenmodes, set it on the resolution I want, click save, reboot...defaults to PAL once again.  How do I change this without doing the mouse button thing every time?

Thanks,
Jeff

[k4lmp]

Yeah, after the MagicWB install.  Where on the board is J102?  I have looked for it, but was never able to find it.

Thanks,
Jeff

[k4lmp]

Well, I found the jumper JP102.  I was gonna solder a pin on each pad for a jumper, so it could be changed, but, with a 15w iron, and about 1/2 a second on the pad, it separated from the board.  It is still attached by the trace, however.  So I just made a solder jumper across the two pads, and all is well.  Boots up NTSC now by default.  I can still hold both mouse buttons down and boot into PAL if I want to.  Thanks for the help.

Jeff