Welcome, Guest. Please login or register.
Amiga Kit Amiga Store Iridium Banner AMIStore App Store A600 Memory

AuthorTopic: CSA 12 Gauge Accelerator  (Read 626 times)

0 Members and 1 Guest are viewing this topic.

Offline Zoomug

CSA 12 Gauge Accelerator
« on: March 15, 2007, 09:10:26 PM »
Hi all. I have just got myself a second hand CSA 12 Gauge 68030 50mhz accelerator board for my A1200.
 When i plug the board in and try to boot, i just get a red screen and a flashing power light. The machine trys to re-boot, but goes through the same again.

I did read somewhere, that it dont like the 3.1 roms, so i changed them back to my old 3.0 roms. This time the screen went balck and the machine still did not boot.
I have also tried changing the sims, even removing them all together to see if would boot.
Is this e-bay'd card dead, or am i overlooking something guys ..

Please help

Thanks

 :-?
 

Offline da9000

Re: CSA 12 Gauge Accelerator
« Reply #1 on: March 15, 2007, 09:36:56 PM »
Did you play around with the jumpers?

Look at this thread of mine for a link for the jumpers:
http://www.amiga.org/forums/showthread.php?t=26658
(Any gurus reading this, please see if you can answer my questions or give hints in that previous thread. It'd be appreciated!)

I believe mine gave a black screen when using it with KS 3.1, not red. As for red, it means this:

Quote

-Red
ROM error, reseat or replace Kickstart ROMS (this can also be caused by worn insulation covering the back end of the pins that connect an IDE cable to a hard drive, aka short).


Taken from:
http://www.amiga.org/modules/xoopsfaq/index.php?cat_id=3

Play with the jumpers and lets u know if it works. Good luck!