Amiga.org
Amiga computer related discussion => Amiga Software Issues and Discussion => Topic started by: T3000 on June 10, 2004, 03:25:41 PM
-
trying to reformat 4gig hd with os3.5
created an emergency boot disk from cd
boot up with floppy but it doesn't find the CDrom
tried changing the CD scsi address
no luck
wtf?
I know... not enough info to help.
-
You shouldn't need the emergency floppy to just format the HD. Just boot without startup sequence and use the format command. (If the drives don't show, then run SETPATCH and then reboot again without startup sequence)
However, if you wanted to repartition, then that's another story.
-
Remember to copy the device driver for your CD rom to devs: on the Emergency disk. I had to copy atapi.device to devs: before I could use the Emergency boot disk.
If you just need to format the drive, then you could just load the normal Workbench disk.
-
You shouldn't need the emergency floppy to just format the HD.
That's true. But after you have formatted your boot partition, there is nothing you can do with the computer any more, because you have no boot disk and no drivers to access the CD. Sounds quite stupid to me.
To get the emergency disk find the CD-ROM drive, make sure all parts of the CD-ROM drivers are available. Load the file Devs/DosDrivers/CD0 or Devs/DosDrivers/EMERGENCY_CD (whatever it is called) into a text editor.
Read the lines FileSystem= and Device=. Check that is present in the L directory of the emergency disk and that is either the name of your countroller's firmware driver or is present as file in the Devs directory.
Also make sure, if you need additional driver programs like IDEfix or SpeedUP, that these are in the C directory of the emergency disk and that they are called in S/Startup-Sequence.
Bye,
Thomas