Amiga.org

Amigakit Hardware => A600GS & A1200NG => Topic started by: NeilB on July 24, 2025, 05:19:43 PM

Title: A600GS Workbench 3.2.2 Unable to enable RTG.
Post by: NeilB on July 24, 2025, 05:19:43 PM

Hi all,

  Setup

  I have updated the latest firmware for the A600GS.
  I have created a new 'system', added the correct kickstart rom, set Z3 to limit to 1G, enabled RTG.
  After installing 3.2 and updating to 3.2.2 - I installed the latest version of P96 (3.5).
 
  Issue

  P96Prefs is not recognizing any video support. I only have the basic screen modes.


  I note from the forum, this worked last year.  If anyone has set this up and been successful, please can you point in the right direction.

 Many thanks, Neil

Title: Re: A600GS Workbench 3.2.2 Unable to enable RTG.
Post by: SkulleateR on July 24, 2025, 05:39:26 PM

You have to change the Boardtype to A600GS on devs/monitors/uaegfx.info

See here : https://forum.amiga.org/index.php?topic=77044.msg862484#msg862484

Title: Re: A600GS Workbench 3.2.2 Unable to enable RTG.
Post by: E5150 on July 28, 2025, 10:11:28 AM

Quote from: NeilB on July 24, 2025, 05:19:43 PM

Hi all,

  Setup

  I have updated the latest firmware for the A600GS.
  I have created a new 'system', added the correct kickstart rom, set Z3 to limit to 1G, enabled RTG.
  After installing 3.2 and updating to 3.2.2 - I installed the latest version of P96 (3.5).
 
  Issue


  I note from the forum, this worked last year.  If anyone has set this up and been successful, please can you point in the right direction.

 Many thanks, Neil

Rename board type to A600GS.
On a custom system with AmigaOS 3.2.+ if I install any newer version of P96 other than the free one from Aminet (P96 2.0) it does not work for me.