Amiga.org

Amigakit Hardware => A600GS & A1200NG => Topic started by: phipslk on December 29, 2024, 05:24:09 PM

Title: Where to put green cable?
Post by: phipslk on December 29, 2024, 05:24:09 PM

okay, I admit, I opened the case to make a backup of the sd card. May be paranoid, but I prefere to have a backup.
Sadly the green cable went off from the GPIO board and I don't know, where to put it back to. In a video I saw, it was the second pin on the upper row. Is that right?

Title: Re: Where to put green cable?
Post by: SkulleateR on December 29, 2024, 05:30:43 PM

see attachment :)

Title: Re: Where to put green cable?
Post by: amyren on December 29, 2024, 05:33:06 PM

That is correct. For that 13 pin Expander (CN105) Green goes to pin 2, yellow = pin 7, blue = pin 8
You can see that the pin no 13 is labeled (printed on the board) so that you know that pin no 1 starts on the opposite side of the header.

Title: Re: Where to put green cable?
Post by: F0LLETT on December 30, 2024, 09:17:54 AM

Quote from: amyren on December 29, 2024, 05:33:06 PM

That is correct. For that 13 pin Expander (CN105) Green goes to pin 2, yellow = pin 7, blue = pin 8
You can see that the pin no 13 is labeled (printed on the board) so that you know that pin no 1 starts on the opposite side of the header.

All cable colours are random. So I would not quote colours. Middle is always pin 2 (GND), as thats the way I have delibrately soldered every single one.