Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: Airshark on October 18, 2024, 06:26:12 AM
-
I'm installing a BFG9060 in my A3000, and the instructions mention that after installation and testing, it is important to install the four "nylon standoffs around the KEL area". What is that? I don't know what these nylon standoffs look like,but whatever they are, I haven't got any. Can anybody direct me somewhere I can get some, or at least give me a proper name and description so I can hunt for them at the electronics store?
-
I'm installing a BFG9060 in my A3000, and the instructions mention that after installation and testing, it is important to install the four "nylon standoffs around the KEL area". What is that? I don't know what these nylon standoffs look like,but whatever they are, I haven't got any. Can anybody direct me somewhere I can get some, or at least give me a proper name and description so I can hunt for them at the electronics store?
They are something like this Nylon Stand Offs. (https://www.beeplastic.com/cdn/shop/products/H2a37fe8910104d0a9b9181eaecb5f3d0K.jpg?v=1689256150&width=600)
I personally do not know size you need. You would need to measure between the 2 boards, while installed to get right height, then measure holes to get right diameter.
-
You can buy 3D printed ones off eBay. I managed to buy some proper ones off a seller on Amibay. I have I. The past used plastic barrel nuts and screws. These are plentiful on ebay.
Maybe something Amigakit could sell in the future? Just a thought.