Amiga.org
Amigakit Hardware => A600GS & A1200NG => Topic started by: SkulleateR on September 22, 2024, 05:41:03 PM
-
I´m trying to replicate my A4000 setup but I can only select 8MB Fast instead of 16MB, is that supposed to be that way ?
And if so : why :'( ?
-
Replicate how?
Altering Amibench or selecting A1200 config?
-
Replicate how?
Upload kick 40.068 from A4000D, selecting A4000 Config and put in WB 3.1 Disk ...
-
I suppose the easiest way to achieve this is to open up your A4000D and remove some fast memory chips :D
just kidding of course. I am still waiting for my unit to be shipped so I'm curious about how it all works.
But there might be another issue regarding emulating a A4000, the cpu.
According to the information at github (BlitterStudio/amiberry/wiki/ information there are two amiberry versions available, Amiberry and Amyberry-Lite.
Lite is supposed to be used for slower hardware up to Pi4 speed, so I guess this is the version in use for the Orange Pi Zero 3 (A600GS)
From the wiki:
Cycle accurate for 68000 mode only, stripped down CPU emulation for other models. Models higher than 020 (030-040) don't use proper CPU cycles, they are just faked using 020 (they still show up as the selected model under emulation, of course). No 68060 support.
You could probably compile your own full Amiberry version, but I guess it would be slower on this hardware.
-
I´m trying to replicate my A4000 setup but I can only select 8MB Fast instead of 16MB, is that supposed to be that way ?
And if so : why :'( ?
As you might have discovered yourself by now, although the setup selection only goes up to 8MB, an 8MB additional memory is added anyway when using the A4000 setup. So you will get 16MB anyway. You can even add some slow ram on top of this.
-
I´m trying to replicate my A4000 setup but I can only select 8MB Fast instead of 16MB, is that supposed to be that way ?
And if so : why :'( ?
Sounds like you emultating in Windows, if so WinUAE? To get to 16Mb and more use the Z3 slider not the Z2 for fast ram.
Sorry did not see this was for the GS, apologies!
-
Sounds like you emultating in Windows, if so WinUAE? To get to 16Mb and more use the Z3 slider not the Z2 for fast ram.
Sorry did not see this was for the GS, apologies!
But the same reason applies, the memory settings are for basic fast ram / Z2 so only go up 8 Mb each or Chip and fast and only 2Mb chip if more than 2Mb fast
-
But the same reason applies, the memory settings are for basic fast ram / Z2 so only go up 8 Mb each or Chip and fast and only 2Mb chip if more than 2Mb fast
And those extra 8MB which is hidden in the RAM selection are Z3 RAM?
-
The A4000 can have up to 16MB Fast Ram on the Mainboard ! That should at least be available if you make an special A4000 Config in the A600GS, that´s my point ...