Amiga.org
Amiga computer related discussion => Amiga Software Issues and Discussion => Topic started by: bradhansen1 on July 25, 2024, 10:47:56 AM
-
Hello All, I am trying to setup my PiStorm32 lite on my A1200 to connect to Wifi using
the Pi's wifi configuration. I am trying to run MiamiDX to do this. I noticed a number of
folks are using this software. However after I install the MiamiDX Software, which sets up
ok. Then I try launch the it, I get an error that says "Unable to open MUI Module." I have
added the 2 MUI modules to the install without issue, but the software can't seem to find
them. Any help that I can get on this would be much appreciated.
Regards,
Brad Hansen
-
Which MUI modules is it asking for and where did you put them?
-
Hello All, I am trying to setup my PiStorm32 lite on my A1200 to connect to Wifi using
the Pi's wifi configuration. I am trying to run MiamiDX to do this. I noticed a number of
folks are using this software. However after I install the MiamiDX Software, which sets up
ok. Then I try launch the it, I get an error that says "Unable to open MUI Module." I have
added the 2 MUI modules to the install without issue, but the software can't seem to find
them. Any help that I can get on this would be much appreciated.
Regards,
Brad Hansen
Miami DX and Piwifi guide. (https://forum.amiga.org/index.php?topic=76477.msg859213#msg859213)
Just follow this quide exactly. It works perfect using this.
-
Hi, thanks for the help, the Install is not asking for any specific module it just has MUI first checked and then a
blue dot and you just agree to both. I put them in the Miami folder in the Internet folder.
Thanks,
Brad Hansen
-
Hi, thanks for the help, the Install is not asking for any specific module it just has MUI first checked and then a
blue dot and you just agree to both. I put them in the Miami folder in the Internet folder.
Thanks,
Brad Hansen
You put MUI drawer in install drawer from what I remember, then run installer.
It should then allow you to proceed.
-
@bradhansen1 is it a repeat of the problem on this thread, or something different?
https://forum.amiga.org/index.php?topic=71221.0
I have just tried installing MiamiDX on a clean installation of OS 3.2.2.1. I first unarchived MiamiDx10c-main.lha to RAM: and then the Miamidx-10c-MUI.lha archive to the same location which placed a MUI folder in the installation directory.
I've tried a few things and you MUST have all the files and MUI installed for Miami to install successfully, otherwise the installer aborts. I've tried really hard to break the installation routine but it covers all the main opportunities for missing files.
Do you use SnoopDOS? Run it before you try and start Miami and it will hopefully tell you which files are missing
How are you unarchiving the files? It's currently the only thing I can think that might be different. I'm unarchiving the files using the CLI:
lha e <archive name> RAM:
-
Why don’t you just buy Roadshow?
http://roadshow.apc-tcp.de/index-en.php
-
Why don’t you just buy Roadshow?
http://roadshow.apc-tcp.de/index-en.php
Or EasyNET. Beta is being tested at moment.
-
Hi, send me the money and I will be happy to purchase it. Wait, no I won't. I down loaded the demo
and just couldn't figure it out. I also own a copy of EasyNetPro, waiting for the update. I do now have
MiamiDX working. Appreciate all the help.
Brad Hansen