Amiga.org
Amiga computer related discussion => General chat about Amiga topics => Topic started by: jcrubin on April 09, 2018, 02:32:04 PM
-
After receiving my long awaited package from Individual computers I do an unboxing, preparation and installation of my new ACA500+ upgrade for my Amiga 500+. This first means actually doing a downgrade first, removing the old acceleration and re-adding the original 68000. I first make sure everything works after the downgrade before installation.
Following a brief exploration of the menu I choose F7 which allows for a boot with all of the workbench disks mounted virtually so that a hard drive install can be accomplished. So I add a CF card into the boot side and continue.
I did not choose the correct CF card for this, nor did I choose the best partition strategy, but this was a first go around, something I will correct in the next video.
Ive learned that the ACA500+ never seems to be able to do a successful software reboot, always getting a green screen of death. This is not a major issue though.
The boot to workbench was a success, and booted quickly. I then attempt to put the second CF card in just to see what happens and it is detected without issue, though only 4 gigs are shown in workbench.
The next task is prefs, where id display mode I find that HIRES works rather nice through this RGB/HDMI conversion setup, so another win! I then go through the rest of the prefs quickly for good measure.
This is the point where I start with some basic software installations moving it from linux with the aux card starting with
lha.run and moving the lha68k to the workbench:c as lha.
The second install was sysinfo.lha which i first extracted on the cf card first for testing. This also allows me to see the tour of sysinfo showing this computer outperforming an amiga 1200 stock 68020. I then go through the rest of the tour of sysinfo.
Satisfied with the structure, sysinfo is moved into the correct location. But i know that the partitions are wrong and I am bothered as I keep noticing that I only have 512k of chip ram. So its time to do some hardware troubleshooting. I wonder what happened to the fatter agnus?
https://www.youtube.com/watch?v=-V82h1vsrmQ (https://www.youtube.com/watch?v=-V82h1vsrmQ)
-
Use F10 for advanced mode...check the chipram settings. I never use the pre-set F1/F2 modes, as they are missing some of the settings I use.
-
Satisfied with the structure, sysinfo is moved into the correct location. But i know that the partitions are wrong and I am bothered as I keep noticing that I only have 512k of chip ram. So its time to do some hardware troubleshooting. I wonder what happened to the fatter agnus?
If this is still the revision 6A motherboard with Baseboard memory that you wrote about:
here (http://www.amiga.org/forums/showpost.php?p=838132&postcount=1)
I suggest you check your "actual" chip and fast memory totals before adding any other h/w.
#6