Amiga.org

Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: spaceman88 on April 23, 2016, 11:17:38 PM

Title: Scala MM400 Problem
Post by: spaceman88 on April 23, 2016, 11:17:38 PM

I had this happen several years ago and can't remember what I did to fix it. When I start MM400 the screen  is about 4 times larger than the monitor, I can scroll down to the bottom, but I can't get to the right hand side of the screen.  Normally if I boot into PAL mode I can see the entire screen (if I stay in NTSC it looks like it does now). My demo copy of MM300 works fine (in PAL mode). I think it's some kind of PAL/NTSC problem.

Title: Re: Scala MM400 Problem
Post by: Gulliver on April 24, 2016, 01:00:04 AM

You just need to go to the Scala´s configuration screen and adjust your settings properly.

http://obligement.free.fr/gfx/scalamm400_pratique_1.jpg

Title: Re: Scala MM400 Problem
Post by: spaceman88 on April 24, 2016, 01:54:57 AM

Quote from: Gulliver;807458

You just need to go to the Scala´s configuration screen and adjust your settings properly.

http://obligement.free.fr/gfx/scalamm400_pratique_1.jpg

Unfortunately I can't get to the right hand side of the screen to get into the "system" menu.

Title: Re: Scala MM400 Problem
Post by: Gulliver on April 24, 2016, 04:12:00 AM

http://aminet.net/util/boot/NTSC4NTSC_V2.2.lha

Title: Re: Scala MM400 Problem
Post by: AmiDude on April 24, 2016, 11:44:08 AM

Just remove the ScalaMM config file in the "Prefs/Env-Archive" dir.
That should do the trick!

Title: Re: Scala MM400 Problem
Post by: spaceman88 on April 24, 2016, 02:30:56 PM

Quote from: AmiDude;807475

Just remove the ScalaMM config file in the "Prefs/Env-Archive" dir.
That should do the trick!

That did it :-0. I'm going to put a sticky note on the side of the monitor!
Thanks guys.

Oh, sorry ...I should have put this in "software problem" not "hardware problem" wasn't paying attention.