Amiga.org

Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: sarkis on December 28, 2002, 12:53:10 AM

Title: warp engine no manual help
Post by: sarkis on December 28, 2002, 12:53:10 AM
hi all
installing the 72 pins for the first time .......
do the chips face towards the 50 pin scsi or the other way?
did the init2 a smitcheon of flux went on the main board is it a problem and how to clean a small amount of flux off the board...
tia
sarkis :-o
Title: Re: warp engine no manual help
Post by: shIva on December 28, 2002, 01:04:00 AM
first of all : you can not place a simm (i hope you mean them) the wrong way into the slot. for anything else have a look here (http://www.amiga-hardware.com)
this might help you :-D
Title: Re: warp engine no manual help
Post by: Paul_Gadd on December 28, 2002, 01:16:48 AM
@sarkis

Have a look HERE (http://planetcryo.com/amiga/warp4040.html) for a online manual type page.


Title: Re: warp engine no manual help
Post by: sarkis on December 28, 2002, 01:25:11 AM
Quote

shIva wrote:
first of all : you can not place a simm (i hope you mean them) the wrong way into the slot. for anything else have a look here (http://www.amiga-hardware.com)
this might help you :-D

ty butttttttt.......
ive been to the page but it doesnt show the 4 simms installed
thx anyway
sarkis
Title: Re: warp engine no manual help
Post by: sarkis on December 28, 2002, 01:26:42 AM
nbeen there but again no help with the placement of the 4 simms..
wont force them in :)

sarkis
Title: Re: warp engine no manual help
Post by: sarkis on December 28, 2002, 01:28:40 AM
maybe yahoo has a generic pisture of a 72 pin simm holder and how to install?
Title: Re: warp engine no manual help
Post by: sarkis on December 28, 2002, 01:45:12 AM
yahoo turned up generics to install 72 pin simms
sarkis