Amiga.org

Amiga computer related discussion => Amiga community support ideas => Topic started by: Cosmos Amiga on June 20, 2014, 12:17:50 PM

Title: Help needed to build a very small adapter (BlizzardPPC)
Post by: Cosmos Amiga on June 20, 2014, 12:17:50 PM
Hi everyone !


The ppc.library (PowerUP) into the BlizzardPPC firmware fail with zero fastram available
when 1 Mb Kickstart plugged in the rom sockets.

So, we need to remove this ppc.library from the firmware and put it if needed into
Sys:Libs/ on the harddrive...

I have disassembled the last firmware v44.71 and removing this library is simple now...

But, the original TSOP eeprom 29F040 have too tiny pins, and soldering/desoldering is
a bit risky you know... I want to keep safe my beloved BlizzardPPC...

So, I need a very simple adapter, only tracks and zero components...

It's a 45 minutes job under Eagle (I need a .brd file for http://www.oshpark.com)


Anybody wanna build this adapter ?



Thanks in advance !




:)
Title: Re: Help needed to build a very small adapter (BlizzardPPC)
Post by: Cosmos Amiga on June 20, 2014, 12:18:25 PM
Some progress :


ppc.library v46.35 removed

New checksum calculated for a new firmware v44.72 ready to go...

Cannot wait to have a try...


Anybody for building this usefull adaper ?




:)
Title: Re: Help needed to build a very small adapter (BlizzardPPC)
Post by: donpalmera on June 20, 2014, 01:45:05 PM
If you want connect to the existing rom you'll need an expensive test clip.
You could take that rom off to read it and put it back with a $50 hot air rework station, some flux and kapton tape.
Title: Re: Help needed to build a very small adapter (BlizzardPPC)
Post by: Cosmos Amiga on June 20, 2014, 02:34:04 PM
Even with hot air, soldering is risky : tiny pads can go away with the heat...




:(
Title: Re: Help needed to build a very small adapter (BlizzardPPC)
Post by: CrashMidnick on June 20, 2014, 03:16:32 PM
I think he knows that ;)
When you remove the flashrom many Times it increase the chance to break a leg or a trace. More over it takes about half an hour and not all people have the skills for.
Good idea Cosmos !
Title: Re: Help needed to build a very small adapter (BlizzardPPC)
Post by: Cosmos Amiga on June 20, 2014, 03:38:24 PM
The ppc.library was compacted : I depacked it and it's the v46.35...

The last ppc.library released for the CyberStormPPC was the 46.31...


Of course, for fixing this adapter on the BlizzardPPC, I'll use "scotch" in french : http://www.castorama.fr/store/Adhesif-double-face-special-miroirs-22-mm-PRDm123100.html



:)
Title: Re: Help needed to build a very small adapter (BlizzardPPC)
Post by: Cosmos Amiga on June 20, 2014, 04:03:08 PM
Without the ppc.library, I have now about 332 Kb free into this new v44.72 firmware...




:)
Title: Re: Help needed to build a very small adapter (BlizzardPPC)
Post by: Matt_H on June 21, 2014, 12:11:56 AM
So what cool new features are you working on? :)