Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: AAACHIPSET on December 23, 2013, 10:27:09 AM
-
just playing ..yet again ..when i remembered a comment on the 3c589.device for pcmcia cards ..an a comment on a 3c589d.device ?..apon looking at my card it has 3c589d on it an my cable has 3c589c on it ..the cable i got seperate from the card ..cable says it works with the etherlink111 lan pc card ..are these drivers different? ..
almost to the point of giving up on this card an tryin to find a new one with all the software etc a prism device... ?.or a usb net card ..though my usb is slow on my external hardrive ..would be slow on net i guess ..
also on subject on networking id like to parnet with pcnetwork my amiga to my laptop like i used to...my newer laptop pent4 doesnt have a parallel port ..do the usb to parallel adaptors work on the pc side to run the cable to the a1200 parallel port?
-
Have you looked at one of the plipbox's
Uses an Arduino, with an Ethernet adapter to give you internet via the parallel port.
http://lallafa.de/blog/amiga-projects/plipbox/
-
Here is quite a decent list of compatible PCMCIA cards:
http://www.g-mb.de/pcmcia_e.html
Easiest option probably is getting a card that works with cnet.device because it supports so many different brands and types.
-
3C589... and Etherlink III are basically the same. If you're not sure the hardware is OK, try it in a PC laptop.
-
maybe the same ..3c589 ..i tried em all ..it says 3c589d on the cable..checked the card in my laptop installed no probs at all
-
You could try this disk:
http://jpv.wmhost.com/NetworkBootDisk/
This disk will help you to set up a network access.
-
Can you specify what problems you have? Do you get any error messages? Also, which network stack are you using?
-
basically i cant get past gettin the 1200 to recognize the network pcmcia card ..bought the etherlink111 cable to go with the card i had ..either the card or the cable or both are not compatible ..supposed to work with the 3c589 but my 1200 cant find the card (etherlink111) ..tried miami ..an the genesis setup ..no go..just waiting till i can find afford a new card that definatley works..
it says 3c589d on the cable ..not 3c589 ..maybe why?