Amiga.org

Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: DaNi on January 23, 2004, 11:51:25 AM

Title: Blizzard IV Fast SCSI 2 Question
Post by: DaNi on January 23, 2004, 11:51:25 AM

hello, any know any method for put this scsi in mode SYNCHRON and save the changes to the controller? for put this i need load every workbech session and load the unitcontrol and put it manuality, but when my amiga is reset the scsi back to asynchron mode. any help for this?
thanks

Title: Re: Blizzard IV Fast SCSI 2 Question
Post by: lempkee on January 23, 2004, 11:54:16 AM

use unitcontrol in your startup-sequence and use "FORCE" ..

anyway i am on ppc so here i dont need unit control :) as bppc has early boot menu :)

Title: Re: Blizzard IV Fast SCSI 2 Question
Post by: patrik on January 23, 2004, 03:40:06 PM

@DaNi:

With the partitioning software supplied with the card you can set each drive to default to synchronous transfer mode.


/Patrik

Title: Re: Blizzard IV Fast SCSI 2 Question
Post by: haymiggan on January 23, 2004, 04:31:28 PM

I just recently had the same problem, and i just added unitcontrol to my US , check in cli with unitcontrol ? for possible attributes. You just need to use a period and a offset to make it sync.

Cheers,
Haymigga