Amiga.org

Amiga computer related discussion => General chat about Amiga topics => Topic started by: wrath of khan on October 02, 2012, 02:46:01 PM

Title: Protomold-Low volume injection molded cases.
Post by: wrath of khan on October 02, 2012, 02:46:01 PM

http://www.protomold.com/ProtomoldProcess.aspx

Could protomold be be the ideal way to make cases or parts for a new amiga?
With a company like this we could have an injection molded case and parts.
There is a price quote system on the site that you can use without purchasing to see how much a case in x volume might cost. Something like this may be genuinely feasible and not make e uppy away with the fairies stuff.

Title: Re: Protomold-Low volume injection molded cases.
Post by: Iggy on October 02, 2012, 06:52:49 PM

Sounds expensive.

Title: Re: Protomold-Low volume injection molded cases.
Post by: persia on October 02, 2012, 08:20:50 PM

3D Printing is the way.

Title: Re: Protomold-Low volume injection molded cases.
Post by: kedawa on October 03, 2012, 12:11:00 AM

I can't wait for 4D printing.

Title: Re: Protomold-Low volume injection molded cases.
Post by: Iggy on October 03, 2012, 01:18:27 AM

Quote from: kedawa;710088

I can't wait for 4D printing.

That's so yesterday (or was that tomorrow).