Amiga.org

Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: psodas on August 22, 2011, 06:50:16 PM

Title: GVP 040 Start up Sequence problem
Post by: psodas on August 22, 2011, 06:50:16 PM

Hello to all.

I have an Amiga 2000 with g-force 040 combo at 16Mb fast ram and also a cybervision64/3D. All work perfect in my OS3.9 with boings 1 & 2.
Wanting to get the best from my accelerator I try to install the disk who came with it, from GVP. During the installation I choose the expert user and not install the “SetPatch command” and the “new CPU command” because are earlier versions from this who come with OS3.9.
At the end of installation the program write to the end of user startup sequence file the above lines..

;BEGIN 68040_FastRoM
sys:utilities/GVPCPUCtrl FastROM MoveSSP
;END 68040_FastROM

;BEGIN SetDevice
run >nil: c:SetDevice
;END SetDevice

Now when I reboot, Amiga hung. Also if I move these lines in the first line of startup sequence file (no user) again the amiga hung..... in reset mode now.
What can go so wrong? I know cause the first lines move the Kickstart in the fast memory of controller and reset the system supervisor stack pointer vectors to point to an area of 32-bit fast ram. The second lines I dont know what they do.

Can someone who has solved the problem to help? I believe if it work the accelerator going faster.

Thank you all.(http://www.amibay.com/images/smilies/smile.gif)

Title: Re: GVP 040 Start up Sequence problem
Post by: psodas on August 24, 2011, 08:12:56 PM

Look above link...
 
http://www.amibay.com/showthread.php?p=203611
 
http://eab.abime.net/showthread.php?t=60674