Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: espenbo on July 14, 2011, 08:59:17 PM
-
Hello
I have tride to get my new silversurfer hardware to work, but with no luck.
I boogth it from Vesalia Computer, but they did not send it with a com port cabel, and when I e-mail them, they sent a clock port kabel innsted.... But I found a old flat kabel 9 pin comport kabel from a old PC I have tride to use. But I'm not sure if it's rigth. Anybody now have I can control that I have it rigth?
silversurf-> 9-pin comport
red. upper
1-> 1
2-> 2
3-> 3
4-> 4
5-> 5
red. lover
6-> 6
7-> 7
8-> 8
9-> 9
10->
thise I have ohm out so I think it's rigth.
I have put the silversurfer.device file in the devs directory. Same place the serial.device file is.
I have tride to get Amige explorer to use it. But can't get it to work.
It works with the original seriel device.
I have tride kermit to send and recive. But no luck with the silversurf. Original works.
Please help, what can I do as the next step.
Espen
-
Are you getting "unspecifed error" when trying to use Amiga Explorer?
Try lowering the baud rate on both sides to 9600
Can't help about the cable pin out sorry but I used simple null-modem with mine. I don't think it works with straight thru
-
Are you getting "unspecifed error" when trying to use Amiga Explorer?
Try lowering the baud rate on both sides to 9600
Can't help about the cable pin out sorry but I used simple null-modem with mine. I don't think it works with straight thru
Yes, I have done it.
It was wrong on the cabel. Had to resolder it.
I made a picture to show how I did it. Now I get 115200 from amiga to pc with Aniga Exploer.
Espen