Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: Vlabguy1 on November 22, 2010, 05:14:12 PM
-
Just got this machine(free :).. ) very decent condition. But there is this 15pin female connector that comes out the back??? Is this a video add on board for the 500? I can
post a pic later if needed.
Thanks
Rich
ny
-
Probably has an internal FF/SD card in it. When you open her up, check to see if Denise got gang banged... :lol:
On a side note: anyone that took the time and expense to upgrade their 500 with such a nice accelerator would probably have gone the extra mile to enhance the video out as well. NICE system have you have there. And for free no less? Damn!
-
Mmm.. opps I didn't mean to imply that the 15pin dsub was part of the GVP A530. The connector is dangling out the back of the machine just above the stock video port.
(pics to come later after she is cleaned up)
Rich
ny
Probably has an internal FF/SD card in it. When you open her up, check to see if Denise got gang banged... :lol:
On a side note: anyone that took the time and expense to upgrade their 500 with such a nice accelerator would probably have gone the extra mile to enhance the video out as well. NICE system have you have there. And for free no less? Damn!
-
IIt might be a VGA cable from a Flicker-Fixer type add-on so you can use modern monitors instead of the old 15 KHz monitors.
-
Could well be an Indivision ECS, if so, that's one hell of an Amiga you got there :)
-
Ooo that sounds good! :)..
Rich
ny
IIt might be a VGA cable from a Flicker-Fixer type add-on so you can use modern monitors instead of the old 15 KHz monitors.
-
mmm.. I hope so. I will have to open her up. Doing a bit of cleaning to it now and I must say its looking pretty new. Came with a BigFoot power supply as well ..
Rich
ny
Could well be an Indivision ECS, if so, that's one hell of an Amiga you got there :)
-
Indivision ECS is really, really new. Who would purchase one of those and then give their computer away?
If it's a FF/SD, I bet it's an oldie but a goodie anyway :)
-
Good point .. so I doubt its an ECS. I will have to open the machine up to check
it out.
Rich
ny
Indivision ECS is really, really new. Who would purchase one of those and then give their computer away?
If it's a FF/SD, I bet it's an oldie but a goodie anyway :)
-
You might hit a ICD FFV1/2 or MultiVision 500 scandoubler/flickerfixer.
Not a bad choice for A500.
-
I would have had that case opened up 10 seconds after getting it! It's been an entire day, and still no photos :roflmao: ?
-
I would have had that case opened up 10 seconds after getting it! It's been an entire day, and still no photos :roflmao: ?
+1
-
I would have if I hadn't gotten a ton of other Amiga(s) stuff :).. I would have gotten
more but my car was filled to the brim, hehe.
Soon my photo gallery will be over loaded..hehe
Rich.
PS. I will get to it this weekend as I have Wed., Thurs., and Friday + weekend off.
I would have had that case opened up 10 seconds after getting it! It's been an entire day, and still no photos :roflmao: ?
-
I'm hoping someone can shed some light on the images. Looks like a wire is cut on the MX chip.. Can you tell this is my first A500 :).. Do I need to reconnect this wire before I power her up??
Thanks
Rich
I would have if I hadn't gotten a ton of other Amiga(s) stuff :).. I would have gotten
more but my car was filled to the brim, hehe.
Soon my photo gallery will be over loaded..hehe
Rich.
PS. I will get to it this weekend as I have Wed., Thurs., and Friday + weekend off.
-
No - that version of Kickstart requires the wire to be cut in an A500. Chips were sold like that because in some revision mobo's, requires it to be connected. Leave it the way it is.
So yeah, looks like you have an old ICD FF/SD hooked to Denise like I thought AND a MegaChip board that allows 2MB Chip RAM in that A500. That is a really, really nice freebie you got there :)
Hook her to a VGA monitor and power her up!
-
That wire on the kickstart is needed on older revision motherboards, you remove it on rev 6 or higher boards.
Awesome system!
-
Cool .. thanks for the info :-).. Will do some cleaning of the keyboard now that the machine is apart. So will a flat panel monitor work?
Rich
ny
-
Any idea what monitors will work with the ICD ??
Rich
ny
No - that version of Kickstart requires the wire to be cut in an A500. Chips were sold like that because in some revision mobo's, requires it to be connected. Leave it the way it is.
So yeah, looks like you have an old ICD FF/SD hooked to Denise like I thought AND a MegaChip board that allows 2MB Chip RAM in that A500. That is a really, really nice freebie you got there :)
Hook her to a VGA monitor and power her up!
-
Any idea what monitors will work with the ICD ??
All!
-
I would have to disagree... tried several monitors here at work..
Dell UltraSharp 2000FP
Dell 1905FP
Sony MultiScan 520GS (big crt)..
These did not work..although I would say the 2000fp seemed to want to work..but didn't
Rich
ny
All!