Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: Aminik on August 19, 2010, 08:35:30 AM
-
Hi.
I own a Micronik Z3 68060 board and i am on the process to install it on my A1200T.
One of the problems i have is that i cannot seem to find the adapter for making use of the busboard video slot. Does anyone knows if there is a possibility to use another adapter, such as the Elbox Z4 video slot enabler?
I also want to ask if drivers are needed to work with this board because i cannot seem to find any of them around the community.
Thanks in advance
Nick
-
No drivers needed.
-
Just use 123.device for the SCSI controller and you are good to go :-)
For the record, it's a 6860 MicroniK board, not 68060.
-
Thanks guys! What about the video slot enabler? Is there a chance the Elbox ne can be used instead of the Micronik? (extremely hard to find)
-
Pass on the video slot enabler question, sorry.
But what do you need it for? A scandoubler? If so, it might be easier for you to find a surface mounted scandoubler instead of finding a video slot enabler.
-
I would pass on the video-slot enabler, it is a bit of a mess with three different clip ons on the motherboard IIRC. Wait for the Indivision AGA instead.
Dont think the Elbox version will fit but not 100% on this.
-
probably you right, besides its even more rare to find a scandoubler for video slot that supports AGA. I might use an old eyetech scandoubler that comes cheaper and its easier to find.