Amiga.org

Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: samplist on June 01, 2010, 01:00:13 PM

Title: Indivision AGA and HP ZR24W incopatibility
Post by: samplist on June 01, 2010, 01:00:13 PM

Hello to all, i recently purchased an HP ZR24W monitor (great monitor btw) but unfortunately it doesn't accept the signal from my indivision AGA. It keeps saying it's out of range. I played with the settings in indivision config tool (latest firmware), tried 1.0 and 1.25 rates and Horizontal and Vertical sync adjustments but to no avail. Is there any way i can connect my A1200 to my new monitor, maybe using an intermediate vga box of some sort?

HPZR24W specs here http://h20000.www2.hp.com/bizsupport/TechSupport/CoreRedirect.jsp?redirectReason=DocIndexPDF&prodSeriesId=4101131&targetPage=http%3A%2F%2Fbizsupport2.austin.hp.com%2Fbc%2Fdocs%2Fsupport%2FSupportManual%2Fc02049456%2Fc02049456.pdf

Title: Re: Indivision AGA and HP ZR24W incopatibility
Post by: alexh on June 01, 2010, 04:23:26 PM

Quote

Vertical Frequency    59 to 61 Hz

This is a very unusual monitor. It has an unbelievably narrow vertical refresh operating range. You'll need to change the Indivision scan rate to 1.0 and use an NTSC screen mode.

If you cannot get it to work, contact your Indivision AGA vendor with the details and they can advise.

Title: Re: Indivision AGA and HP ZR24W incopatibility
Post by: samplist on June 01, 2010, 04:43:19 PM

thanks alexh i'll try that and see what happens