Amiga.org
Amiga computer related discussion => Amiga Marketplace => Topic started by: VingtTrois on April 23, 2010, 08:10:25 AM
-
SCSI CHIP AM33C93A-16PC for A3000 and others AMIGA Cards
This Chip is NEW and not used but is tested / works fine!
For:
- COMMODORE AMIGA 3000 Desktop ou Tower
- A1000 SCSI
- AdSCSI (Advantage) 2000
- AdSCSI 2080
- CDTV to SCSI Interface
- GVP Impact A2000-1/X
- GVP Impact A2000-SCSI+2
- GVP Impact A2000-SCSI+8
- GVP Impact A500-SCSI (à vérifier)
- GVP Impact A500-SCSI+4
- GVP Impact A500 HD8+ Series II (Rev.3 only)
- COMMODORE A2090 / CBM A2090A / CBM A2090B
- COMMODORE A2091
- COMMODORE A590
- Comspec SA-1000 (must be checked)
- Comspec SA-2000
- Comspec SA-500 (must be checked)
- etc...
In some cases, you must check if the WD chip must be desolder and "40 pin DIP chip socket" should be installed (not included here).
Delivery in rigid plastic case.
Price: 15 EUR (included P&P worldwide) + PAYPAL fee.
PAYPAL only.
AMIGA.RESOURCE.CX (AMIGA 3000):
The built in SCSI host adapter - based around the Western Digital 33C93 SCSI controller - supports up to seven devices connected simultaneously. The controller's configuration is stored in a NVRAM powered by the same battery which the clock is.
SCSI Problems
The A3000 may suffer SCSI related problems when several SCSI devices are attached to the bus. The most common are random SCSI bus lockups, especially with CD-ROMs and tape driver and random checksum errors when copying large files between devices. These problems can, in most cases (providing termination and jumpers are correct) be attributed to the WD33C93A SCSI controller chip in the A3000. Most, if not all, A3000s shipped with the WD33C93A-PL 00-04 chip revision. This chip had known bugs when multiple devices were present on the SCSI bus. The WD33C93A-PL 00-08 chip revision addresses and fixes the above problems.
WD33C93A-PL 00-08 9131 F (Latest Revision)
WD33C93A-PL 00-04 9201 D (default release)