Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: Acill on November 15, 2003, 04:05:54 PM
-
Not that I have any real problems with my system, but I could use some help.
When I set up my Mediator on the A3000 I used all the default setting to get the voodoo 3 working. I heard this isnt ideal, but can never figure out hoe to get better ranges of display modes set up in P96. Every time I fool with it I get freq out of range on my monitor. As I now I have a great looking 800 x 600 display and a slight flicker in 1024 x 768. Its because the vertical frew is only 62HZ I am sure.
Here is what I need. Can anyone using a voodoo 3 and mediator send me the files for the settings so I can try to use them and see if it helps any? PM me for info to send them.
-
We need to know what frequencies ur monitor
supports. :rtfm:
:-D
-
Yes I know, but thats the problem. I havent been able to ind any information on this monitor at all on the net, and I have looked all over the place too. Its a DigiView HR-55 15" monitor. The problem is DigiView is no longer in business as far as I can tell.
-
I just found this information on the DigiView HR-50, which I am sure has the same specs as mine does since the next one after mine is also the same specs as this one. I hope you can give me a guide to the proper P96 setup for this darn thing at last!!!
DigiView HR-50
Dot Pitch .28
Max Res 1024X769
(H)30-50khz (V)47-104hz
Price $147
-
(H)30-50khz
Your monitor is only 50 Khz so your settings are
all correct and maxed out.
If you want better then you need a better monitor.
800x600 75 Hz requires 46.9 Khz
If I were you I would only use that monitor in 800x600
mode.
P.S. Congrats on the new Governator :-D
-
So I assume when I run the install P96 setup and it asks for my monitors max rate I would enter the closest to 50 it offers correct? If so then I am set up as best I can get. Thanks