Amiga.org

Amiga computer related discussion => Amiga Marketplace => Topic started by: doctorq on April 05, 2009, 03:04:07 PM

Title: WTB: GVP ROM 3.15
Post by: doctorq on April 05, 2009, 03:04:07 PM

Hi,

I have a GVP HC2+ with the old v1.0 boot roms and scsidev.device as a device driver. According to information around, this device driver can only handle 1 device, and locks up the SCSI bus when scanning it.

The GVP 3.15 boot rom fixes this problem, and I already have a bootdisk with the BindDrivers driver and it works like a charm with both a harddrive and a CD drive attached. However, using a boot disk is useable but can be a bit annoying in the long run, so can anyone burn one of these ROMs for me at a decent price?

PM me with your price.

Title: Re: WTB: GVP ROM 3.15
Post by: save2600 on April 05, 2009, 05:56:47 PM

Not sure if this will help at all, but I've got a single 28-pin DIP pulled from a GVP combo card that reads: 1991 GVP OMNI 3.5 B062 you're welcome to. Not sure of the difference between 3.15 and 3.5 or if your card would not accept this particular BIOS config...

Title: Re: WTB: GVP ROM 3.15
Post by: doctorq on April 05, 2009, 06:05:18 PM

At least the ROM that needs to be replaced is a 28 pins chip as well, so it might work. Sending you a PM.

Title: Re: WTB: GVP ROM 3.15
Post by: save2600 on April 05, 2009, 06:32:08 PM

Ahh okay, I'd think so too then. GVP didn't monkey around too much with the architecture of the SCSI bus AFAIK.

Title: Re: WTB: GVP ROM 3.15
Post by: nishtek on April 05, 2009, 07:17:36 PM

pm send.  we got 3.15.