Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: XDelusion on March 21, 2009, 08:06:11 PM
-
I won't have the money to order any for a while so in the mean time...
...instead of replacing the PCB on my Atari Joystick, is there some way to get in there with an extacto knife and fix one of the connectors that is nearly flat at this point?
-
Do you mean the contact pads on the pcb or do you mean the connector that plugs into the atari/amiga? I am trying to figure out what you mean by "flat". Is this a classic atari (2600) joystick?
-
Contact Pads...
...they typically have a hump like shape, but my bad one is near flat.
-
You mean the 4 bubbley type things in there? Its been a while since I've opened one. I always kind of assumed once those broke the joystick was toast (at least as far as most home repairs go).
-
Bubbly/Bumpy, yep those things.
-
When you described them as being, "flat" I assumed that is what you meant but wanted to make sure. There is a common method of reviving those contacts using aluminum foil and crazy glue, if I remember correctly.
Head over to atariage.com and do a search..I think there is a tutorial on youtube as well.
'hope that helps.
-
Usually the thin metal sheet is cracked and/or worn out. Probably fixing it won't last too long.
I've successfully replaced those contacts with SMD switches:
(http://www.reichelt.de/bilder//web/artikel/C200/TAST1600.jpg)
I've fitted them either by milling recesses into the stick or from the back of the PCB after cutting a hole. Either is a lot of work, so it'd be much easier to get a decent joystick with microswitches...
-
Have any photos of those mods, zac?
-
No, sorry - gave up on that 15 years ago. ;-)
I haven't done this with an Atari though (only Quickshots and such), so I've got no idea which is the best way.
btw: Before cuttting holes into the PCB make sure its strength isn't compromised too much, otherwise it'll crack very quickly.
-
http://www.atarirevolution.com/atari-repair-parts.html
100 replacement switches for $5.99.
-
I saw that, but ironically have to wait a few days till I have that much money...
...just had car repairs.
Anyhow, thankx, looks like that is the best route in the end.
-
XDelusion wrote:
I won't have the money to order any for a while so in the mean time...
...instead of replacing the PCB on my Atari Joystick, is there some way to get in there with an extacto knife and fix one of the connectors that is nearly flat at this point?
If you want to PM me your address, I'll send you a complete replacement PCB at no charge. Part #CO17025. I'll even pick up the shipping...
-
When I was a kid and we had a 2600, when those things would start to go we'd carefully peel the sticky clear "tape" covering the PCB off and flex the switch/pad until it had a "hump" again, then carefully replace it, put the tape back, et volia.
I had a 2600 stick that lasted from ... '81? until '88, used it on my 2600, then my Vic-20, then the C64, then the 128 and finally my A500, where it finally died during a particularly intense game of Falcon :)
-
save2600: thank you very much and message sent...
...or should be.
-
Great, glad to help out. I should be able to post it tomorrow.
Can't beat the "feel" & gameplay of the original Atari 2600 joystick!