Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: ozkano on May 24, 2008, 08:30:26 AM
-
I bought second hand pegasos 2, and bought a brand new tower for it, I install peg2 board without any problem, now point is, in first boot peg works well and boot, when I reset or shut down and resart computer it does not boot ,no screen, if I unplugged power cable and wait few minutes then it works again.
Yesterday I shut down device but this morning it stoped working, is there any idea ? is it can be same problem as amiga one board cause of low bios battery
-
Hi,
describe well your configuration !
which Peg2 Firmware ?
CPU module rev ?
CGX ?
USB DEVICE ?
PS/2 device ?
HDD and CDROM ?
try also to post on morphzone
-
Does the POST show after a reset?
Any hard drive activity?
Regards
Rich
-
The only common prob I've ever heard from was the CPU-card not sitting tighly, it needs to be pushed in real hard.
-
Don't even try to push the CPU-card real hard, or you will contact Thomas Knabel (bPlan) very soon. :-D
-
sorry for delay
my cpu board is 744x rev 1.1
mainboard is 2B1
-
Yesterday I shut down device but this morning it stoped working, is there any idea ?
With serial cable you could monitor from other computer what is going in the boot process. I cant remember details but someone at MorphZone could help.
is it can be same problem as amiga one board cause of low bios battery
No.
-
probably capasitor problem, i am going to change all capasitors on cpu board