Amiga.org

Amiga computer related discussion => Amiga Software Issues and Discussion => Topic started by: tonyw on August 15, 2003, 01:53:26 AM

Title: Enforcer
Post by: tonyw on August 15, 2003, 01:53:26 AM

I have a 4000 + Cyberstorm 68060. Although I have tried many times in the past and again several times recently, I have never been able to get Enforcer to "work". If I run it from WB or CLI, it says "Enforcer is on the job", but never anything else. If I run "Lawbreaker", it should cause a hit and print something out, right?

But I've never seen Enforcer print out anything except for the greeting message.

I remember when BB1 & 2 came out for 3.9, that H&P said you don't need to run "Move4k" anymore. Is this true? It doesn't seem to make any difference.

Any hints?

tony

Title: Re: Enforcer
Post by: Piru on August 15, 2003, 02:24:39 AM

If you use phase5 68060.library then you should use CyberGuard (http://www.dcecom.de/pub/ppc/68060-191099.lha).

Title: Re: Enforcer
Post by: KennyR on August 15, 2003, 02:27:15 AM

MuForce is also an option.

Title: Re: Enforcer
Post by: tonyw on August 15, 2003, 08:19:02 AM

I've tried Cyberguard with the same result. When I run "Lawbreaker", nothing appears to happen. No fault report, no crash, no return from the task. SnoopDOS does not report any error either.

I haven't tried MuForce, although I have MuTools installed.

Maybe I should try Sashimi as well.

tony

Title: Re: Enforcer
Post by: AmiDog on August 15, 2003, 09:33:54 AM

I think Enforcer by default write the hit to the serialport so you need either another Amiga (or computer) attached to the serialport (I think the speed i 9600bps, but I'm not sure), or you need a program which catches the output and prints it on the screen. I think you just need to figure out which of all the icons to click to get Enforcer started in such a way that any hit will get printed on screen. Or maybe one had to set a CON: tooltype or something...

I'm sure it's described in the manual though.

Title: Re: Enforcer
Post by: shIva on August 15, 2003, 10:07:45 AM

yes, sir. 9600 bps 8N1. the same ROMWACK does. for connecting the other computer to your miggy, you´ll need a nullmodem cable.

Title: Re: Enforcer
Post by: Cass on August 15, 2003, 10:48:05 AM

@tonyw
First, get the latest version of Enforcer (I have 37.73) and make sure that supports the 060. Then edit tha tooltypes. My settings:

FILE=PIPE:guru

Which outputs the errors to a file. In this case is named "guru", and it's a pipe.
To see the output (I don't need a continous popup) on demand, open a cli and type:

"type pipe:guru >*"

(without the "" obviously), and the enforcer hits appear on the console.
________
HANDJOB BLONDE (http://www.fucktube.com/categories/665/blonde/videos/1)

Title: Re: Enforcer
Post by: tonyw on August 15, 2003, 10:56:24 AM

Thanks, guys. I didn't realise the output NORMALLY appears on the serial port, I thought it was only an option.

Duhh.

Where's my old Stinkpad?

tony