Amiga.org
Amiga computer related discussion => Amiga Software Issues and Discussion => Topic started by: stefcep2 on March 05, 2008, 09:36:35 AM
-
Is it possible to open a double scan ie dblPAl or DblNTSC or productivity screenmode for lightwave?
-
with a screen promoter, yes but it will crawl!
NewMode (http://aminet.net/util/cdity/NewMode_V39.lha)
-
Just spotted this in the WaveGuide Manual. Don't know if it helps, it's been a long time.
'The Modeler is actually an independent programme that may be run in a variety of screen modes. These can be selected using the Changemode utility. If you look in the Utilities drawer you will see the Changemode tool and its documentation. Double-clicking Changemode pops a file requester asking you to load Mod-config. Load the file and you'll get a Screen Mode listing, which you can edit. Simply insert the reference number of the Mode in which you prefer Modeler to run and reboot. The selected Mode will be used whenever you enter Modeler directly from Workbench. However, if you enter it via Layout, the selected Mode will not be used unless Mode Promotion is active.
To enable any selected Mode to be used by both Layout and Modeler, go to the Workbench Prefs directory and open the IControl drawer. Here, you will see a button marked Mode Promotion. Click on this with the LMB to switch it on (i.e. highlighted). After a reboot, the selected Sceen Mode will be used for both Layout and Modeler.'
If I remember right, the 'Utilities' drawer here is the one in the LightWave folder not the Workbench/Utilities drawer.
JaX
-
What is "the reference number of the Mode"?
-
Would getmodeid.lha help?