Amiga.org
The "Not Quite Amiga but still computer related category" => Amiga Emulation => Topic started by: stefcep2 on February 26, 2008, 08:04:01 AM
-
Has anyone tried to run Scala MM400 on Winuae. All i seem to get is a corrupted screen and a hang. If anyone did what were your Winuae settings?
-
I've used it with Winuae set up as a 1200 with hard drive and extra Ram. Virtually a bog standard setup. I did get a bit of graphics tearing but not that much.
The finished result wasn't bad but was actually better on my true Amiga.
No hangs though :-)
I'll have a look tonight after work when I'm in front of my home Pc and not the work one :lol:
Dave G 8-)
-
Just tried it and all worked ok. No hangs.
My config is ClassicWB_Full with the addition of assigning the CD. I was running Scala from the CD.
Are you running Scala MM400 from CD or installed on Hard drive?
Dave G 8-)
-
I have ran SCALA MM300 on WinUAE.....I simply installed my REAL Amiga Harddrive into the PC and ran WiUAE with my stuff on the Amiga Harddrive (Yes it reads it) SCALA Ran Just fine with no problems as far as loading...but when presenting graphics and presentations, the graphics looked ripped...it has something to do with the screen refresh rate and VGA monitors I believe..which is why I dont like PC's for Video work.
-
leirbag28 wrote:
I have ran SCALA MM300 on WinUAE.....I simply installed my REAL Amiga Harddrive into the PC and ran WiUAE with my stuff on the Amiga Harddrive (Yes it reads it) SCALA Ran Just fine with no problems as far as loading...but when presenting graphics and presentations, the graphics looked ripped...it has something to do with the screen refresh rate and VGA monitors I believe..which is why I dont like PC's for Video work.
Was vsync enabled?
-
Tomas wrote:
Was vsync enabled?
I've just tried it again with vsync enabled and although there is an improvement I just get a slight tearing on the graphics/text :-(
Dave G 8-)