Amiga.org
Amiga computer related discussion => Amiga Hardware Issues and discussion => Topic started by: Dmaster on January 13, 2008, 08:53:35 PM
-
Hello all, I finally got my A200T alive again, and it's been years since I actually used it. I thought the power supply was dead, just needed cleaning :)
Anyhow, I had to replace the floppy drive with the one from my A500, the one it had could not read at all.
Now the machine boots fine but I keep getting a message on my workbench screen which says "CD0:Unitialized" I cannot read any CD inserted to the unit at all. Is there a way to fix this? Thanks.
P.S. The last time I used it I was able to install OS 3.9 from CD just fine.
-
Click just one time in the CD0: icon on the devs:dosdrivers/ drawer.
Then hold and press . It will bring you a window with the information of the icon.
Look if your tooltype point to SCSI.device unit 1 (assuming the CD is the slave device in the IDE chain). And also check if your HD is set as Master (scsi.device unit 0).
-
Thanks alot, got it working! :)
Next try wiping out everything and re-install OS 3.9 Fresh.
Hope it works! :)